Publicly ISO Available Specification ISO/PAS 22101-5 First edition Polyethylene reinforced with short 2024-07 glass fibres (PE-sGF) piping systems for industrial applications - Part 5: Fitness for purpose of the system Systemesdecanalisationsenpolyethylenerenforcedefibresde verre courtes (PE-sGF) pour les applications industrielles- Partie 5:Aptitudea I'emploidusysteme Referencenumber ISO/PAS22101-5:2024(en) ISO2024 IS0/PAS 22101-5:2024(en) COPYRIGHTPROTECTED DOCUMENT @IS02024 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either Iso at the address below or Iso's member body in the country of the requester. ISO copyright office CP 401 : Ch.de Blandonnet 8 CH-1214 Vernier, Geneva Phone:+41227490111 Email:[email protected] Website: www.iso.org Published in Switzerland IS0 2024-All rights reserved ii IS0/PAS22101-5:2024(en) Contents Page Foreword. .iv Introduction 1 Scope. .1 2 Normativereferences .1 3 Terms and definitions .2 4 Fitness for purpose of pipes and/or fittings assemblies 2 4.1 Method ofpreparation ofassembliesfortesting 2 4.1.1 General 2 Electrofusionjoints .2 4.1.2 Butt fusion joints .3 4.1.3 4.2 Requirementsforfitnessforpurposeofthesystem 3 4.2.1 General .3 4.2.2 Fitness for purpose ofthe system for electrofusion joints 3 4.2.3 Fitness for purpose of the systemforbuttfusion joints 4 4.3 Conditioning 5 4.4 Requirements .5 5 Design coefficient 6 5.1 PE-sGF compound 6 Bibliography 7 IS0 2024-All rights reserved iii