ISO INTERNATIONAL STANDARD 3202 Second edition 1997-10-15 Aerospace -- Screws, pan head, internal offset cruciform ribbed or unribbed drive, threaded to head, MJ threads, metallic material, coated or uncoated, strength classes less than or equal to 1 100 MPa -- Dimensions Aéronautique et espace - Vis a tete cylindrique, a empreinte cruciforme deportee, avec ou sans saillies antiderapantes, filetees jusqu'a proximite de la tete, a filetage MJ, en materiau metallique, revetues ou non revetues, des classes de resistance inferieures ou égales a 1 100 MPa - Dimensions ISO Reference number ISO 3202:1997(E) No reproduction or networking permitted without license from IHS Not for Resale ISO 3202:1997(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. international organizations, governmental and non- governmental, in liaison with Iso, aiso take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an Internationa! Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard isO 3202 was prepared by Technical Committee ISO/TC 20, Aircraft and space vehicles, Subcommittee SC 4, Aerospace fastenersystems. This second edition cancels and replaces the first edition (iSO3202:1991),ofwhichitconstitutesatechnicalrevision @ISO1997 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced microfilm, without permission in writing from the publisher. InternationalOrganizationforStandardization Case postale 56 . CH-1211 Geneve 20 . Switzerland Internet [email protected] X.400 C=ch; a=400net; p=iso; 0=isocs, S=central Printed in Switzerland ii Copyright International Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale INTERNATIONAL STANDARD @ISO ISO 3202:1997(E) Aerospace --- Screws, pan head, internal offset cruciform ribbed or unribbed drive, threaded to head, MJ threads, metallic material, coated or uncoated, strength classes less than or equal to 1 100 MPa Dimensions 1 Scope ISO3353:1992.Aerospace Rolled threads forbolts Leadand runout requirements. This international Standard specifies the dimensions of threaded to head pan head screws, with internal ISO 5855-2:1988, Aerospace --- MJ threads - Part 2: offset cruciform ribbed or unribbed drive, MJ threads, Limit dimensions for bolts and nuts. in metallic material, coated or uncoated, with strength classes less than or equal to 1 100 MPa. IsO 7913:1994, Aerospace Bolts and:screws, metric-Tolerancesofformandposition. This International Standard is applicable for the compilation of aerospace product standards. IsO 14275:--1), Aerospace -- Drives, internal, offset cruciform, ribbed - Metric series. Iso 14276:—1), Aerospace Drives, internal, offset cruciform - Metric series. 2 Normative references Thefollowingstandardscontainprovisionswhich through reference in this text, constitute provisions of 3 Configuration and dimensions this International Standard. At the time of publication, the editions indicated were valid. All standards are See figure 1 and table 1. Dimensions and tolerances subjecttorevision,andpartiestoagreementsbased are expressed in millimetres. They are applicable after on this International Standard are encouraged to any surface coating, but before the application of any investigate the possibility of applying the most recent lubricant. editions of the standards indicated below. Member